|
Basic Application:
1/ We recommend trying a small amount of polishing compound in an inconspicuous area of the surface, to check its suitability.
2/ Make sure the surface to be cleaned is free from dirt, dust and grit before using the cleaning system. A dirty surface may affect the finish of the job and could result in scratched glass. (EG: If you live in a coastal area, sand deposits may be present on exterior windows AND MUST BE REMOVED BY WASHING THOROUGLY)
3/ Use a small amount of clean water to wet the surface to be cleaned. A spray bottle is ideal for this or if one is not available, a water saturated cloth will do the job.
4/ Cover any items that may get polishing compound splatters on them during the cleaning process.
5/ Apply a minimum of a 3mm thick coating of the polishing compound evenly over the entire surface of the non-scratch pad (Add the paste to the scratch proof pad using a clean utensil, do not use the applicator pad to scoop out the compound)
6/ Use the pad to spread the polish over an area of about 200mm square
7/ Set your drill on a lower speed- Too fast and the product will fly off the pad, the surface will get hot and the product will dry out.Too slow and the job will take longer to achieve the desired result.
Start with your drill placed against the surface.Work, moving slowly across the work surface in sections, slightly overlapping on each pass. Do not rush the job! Some patience is required to achieve a great end result. If using the hand applicator pad, ensure that firm, but even pressure is applied to the surface and use small back-and-forth movements.
8/ After a small area has been polished, wipe it down with a damp cloth and check your cleaning progress. Some extremely tough stains and marks may require a second application.
Important:
Do not be tempted to use too much Glass Clean compound on the surface being cleaned. This will reduce its effectiveness. It is also important to keep the area being cleaned irrigated with clean water.
DO NOT LET THE SURFACE DRY OUT!
A spray bottle is ideal to "mist" water over the area. when using the drill kit this may be required every two or three passes.
Always ensure the surface being polished is coated with polishing compound. A surface without any polishing compound will not effectively remove stains.
Sometimes, depending on the severity of the staining, a second application may be required.
IF IN DOUBT, CALL OR EMAIL US.
Quick tips
Do not use in direct sunlight if possible. Sunlight will dry out the compound faster and make the job surface more difficult to clean properly.
Spraying water on the surface being cleaned can assist in the cleaning process.
Not for use on surfaces such as: Eye glasses, perspex, acrylics, and plastics.
Do not use a cleaning pad that has been used on tiles first, on glass afterwards.
Safe to use, safe on your hands and skin and contains no harsh chemicals. Glass clean will not affect rubber window seals and can be easily wiped from surfaces it comes into contact with.
The hand applicator pads (supplied in the Drill Kit) can also be trimmed to fit the velcro drill backing pad and may be more effective against some very stubborn stains.
Use water to clean up Glass clean from all surfaces and drill attachments.
Glass Clean cannot be held responsible for any damage, loss or liability arising from the use of this product.
|
